I have a RV082.
I need to disable the firewall, since firewalling is done better elsewhere.
However disabling firewall Remote management on wan ip is forcefully enabled.
I don't need Remote management, keeping it enabled is a security risk for my setup.
I don't understand the rationale behind the choice to forcefully enable remote management if firewall is disabled.
Is there a way to disable both firewall and remote management?
Or at least a workaround?
I'm on firmware 126.96.36.199-tm on a probably v2 hardware. (Cannot find this info in the web configuration).
This is not the newest even for v2 hw but I cannot afford to break it trying to upgrade the firmware.
Moreover no release notes for firmware releases refers to a correction of firewall/remote management behavior.
Is this behavior also in newer firmware releases?