cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
319
Views
0
Helpful
1
Replies

RV082

freeness4
Beginner
Beginner

Using dual wan, I am trying to get 2 PCs to only use WAN 1 for all traffic.  I've tried bandwidth management and protocol management, but about half of the time I go to whatismyip.com it shows me the IP of WAN 2.

Bandwidth management, using rate control, seemed pretty straight forward, but it didn't work.  

With protocol management, I'm not certain what to put in for the destination IP range.  I want all traffic to/from all external sources for internal IP 192.168.0.10-19 to use WAN 1 exclusively.  

How can I set this up?  Thanks.

1 Reply 1

Glenn Martin
Cisco Employee
Cisco Employee

moving post to the Small Business > Routers community

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers