Hi everyone
I am attempting to configure the RV220W (Firmware 1.0.6.6) for dot1x authentication over a Windows 2008 based RADIUS Server (using Remote Access Services).
The RADIUS settings on the RV220W are pointing towards that W2008 Server. The SSID has been set up for "WPA2 Enterprise" Security.
All the authentication attempts arrive at the server, but they fail to get authenticated because the Cisco RV220W is not transmitting a "NAS Port-Type" and therefore, the RADIUS Server will reject the requests.
This is what the request from the RV220W looks like on the server:
And this is a request from a similar Zyxel Router:
How can I enable the Cisco RV220W to send a NAS Port-Type (19, Wireless 802.11)?
Thank you for your support!
