Hello everyone,
We are using a RV320 router for over 1,5 years now.
From our provider we have been using 1 static IP adres :
111.111.111.111
and we also have been given a couple of external adress wich are in a different IP range say :
222.222.222.22X
In the past (i think earlier firmware) we were able to use nat-to-nat to setup nat routing for the ip in the 222.222.222.22x range.
But i tryed to make some adjustments to it but i failed, because it says the IP adress should be in WAN Subnet IP range
What am i doin wrong ? I have added a screenshot. So one day i was able to make the setting but now with most current firmware i am not so. What are we doing wrong ? Or is this a bug in firmware ?
