The following problem: S2S VPN between an RV340 and an RV 130. Address spaces 192.168.1.0 and 92.168.2.0. The access from the network of the RV 340 to the network of the RV130 works without problems, conversely, no data is transmitted. No address in the range 192.168.1.xxx can be called.
66
2018-10-01 09:33:10
debug
ripd[10263]: multicast announce on lan side
67
2018-10-01 09:32:56
warning
pluto[22112]: "AGS" #20: STATE_QUICK_R2: IPsec SA established tunnel mode {ESP=>0xca8051e6 <0x7b95a2a7 xfrm=3DES_0-HMAC_MD5 NATOA=none NATD=none DPD=enabled}
68
2018-10-01 09:32:56
warning
pluto[22112]: "AGS" #20: transition from state STATE_QUICK_R1 to state STATE_QUICK_R2
69
2018-10-01 09:32:56
warning
pluto[22112]: "AGS" #20: Dead Peer Detection (RFC 3706): enabled
70
2018-10-01 09:32:56
warning
pluto[22112]: "AGS" #20: STATE_QUICK_R1: sent QR1, inbound IPsec SA installed, expecting QI2
71
2018-10-01 09:32:56
warning
pluto[22112]: "AGS" #20: transition from state STATE_QUICK_R0 to state STATE_QUICK_R1
72
2018-10-01 09:32:56
warning
pluto[22112]: "AGS" #20: keeping refhim=4294901761 during rekey
