Site to Site VPN with RV180 to 5510 ASA

[helpdesk-md]

   Hello All, I am trying to establish a site to site VPN with a RV180 connecting back to a corporate Network using an ASA 5510.  I have the RV180 setup with the Remote IP setting and a FQDN all setup and  I am able to tracert back to the ASA but I wanted to know if I have to modify anything on the ASA side and how do I setup a pre-share key to establish the secure connection.  Any suggestions would greatly help.  Thanks

[jonatrod]

Good morning

Hi Jeff, thanks for using our forum, my name is Johnnatan and I am part of the Small business Support community. I ´ve seen your post and I found some information related to your RV180

http://www6.nohold.net/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=2863

http://www6.nohold.net/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=2284

http://www6.nohold.net/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=2265

http://www6.nohold.net/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=2264

Also if you want to configure the preshared key in your ASA5510 you can setting up with this commands:

crypto isakmp enable

authentication pre-share

crypto isakmp key address/ hostname 

If you need more help you can post your question in  Security > VPN so you can have more feedback on your case, more users will see it there. I hope you find this answer useful,

*Please mark the question as Answered or rate it so other users can benefit from it"

Greetings,

Johnnatan Rodriguez Miranda.

Cisco Network Support Engineer.