I need a host on the production vlan with a service running on port 60443 to be reachable from the outside by an external internet host. I've created the appropriate ACL and NAT rules but the traffic doesn't go through. A packet tracer simulation say...
Hello, Is there any way I can stop the frames from leaving the queue for sometime(assuming the queue won't be full in the meantime)?
Hi, We notice high CPU utilization over our CISCO2911 device and our tool reports high cpu alert accordingly. During this high utilization alert we notice that the SNMP engine process is showing pretty high as can be seen in below output show proce...
Hi Guys Do i need SD-WAN solution for my 50 Branches connected all together over internet using DMVPN , we don't have any hosted resources on cloud like office 365 or MS Skype for Business , as i heard SD-WAN is more usefull if u app hosted on cloud ...
Hello everyone, I am currently working on simulated network environment in preparation for a real-time environment. Within my network environment I have two routers connected by a GRE tunnel/ipsec vpn using EIGRP as a routing protocol. I then have Ne...
I have purchased 2 cisco rv042 vpn router and wants to connect 2 sites thru vpn, I have configured my vpn router behind adsl router configured in bridge mode, also configured my cisco wan as pppoe mode, I also having static ip address, both the vpn r...
Hello, I want to make the router not do anything(even if there are packets in the buffer) for some time(predetermined) after matching on a particular packet(on destination mac address). Is there a delay command which I can use in this case to make th...
Hi Guys,As you see the below configuration, I want to be able to access a device (192.168.1.100) using port 7331 and 7332 from outside the network using the external ip address and port 7331 and 7332. But when I tried to check the port status usin...
Are anyone have sample config with 3 hubs with fail over .Currently i am using dual hub and it working perfectly. Spoke to Spoke communication is not required. I am trying to achieve failover between the 3 Hubs. All the 3 Hubs will have separate Publ...
I have connected a modem on switch port 23 and below config is the config on router subinterface and switch port.This is not working. I can't ping the next hop x.x.x.97. This was working when modem was connected directly to the router.Any suggestions...
Hello, i'm investigating an unusual behaviour with our DMVPN and hoping someone can point us in the right direction.We have a 3-hub solution with numerous branch office spokes using BGP on the WAN and EIGRP for tunnel routing. The majority of office...
dears i got recently the details from the isp to configure it on my router ( for the internet connection) as below , and i have my configurations already on router and switch ill paste it here :- on wan interface ( g0/1) i should put this ip 172.19.1...
Hi, I have a question about the path selection on CE in MPLS network:The attached is the topology. 1. In MPLS network, 3 PE's are in separate AS number, AS1, 2, 3. 2. in each site, CE sets up iBGP with the local PE. 3. Only CE's in AS1 & 2 can be con...
Hello experts, I just want to verify is this setup will work properly or not.My notebook is behind WANSW1. Now If Te1/1/3 interface goes down on WANSW1 then which route will used to go to CoreSW1 ? My aim is to achieve:1. 1st route via Te1/1/3 from W...
I am using packet tracer tool to create two simple networks. In topology, I have two routers connected together with network 192.168.3.0. The problem is that when I change the IP addresses of routers to "192.168.3.1/8" and "192.168.3.2/8", everything...
