The ipsec VPN server configuration form displays a lot of inactive fields, so I am unable to follow the instructions given in, for example, the documentation here. I tried setting only the fields I could get to, but the values are not saved. My con...
Hello, I've been trying to run 2 VRFs in a small GNS3 lab to help me understand it better before doing in on real kit in a couple of weeks. I've managed to do it in EIGRP before on other networks but I've not tried in in EIGRP. I had another post bu...
I like to set up a Viptela SD-WAN lab in Cisco cloud, what are the requirments and how do beging?
Ive been working at this for a while now, and I can not get the vbond device to work. I've been following this guide: https://sdwan-docs.cisco.com/Product_Documentation/Getting_Started/Viptela_Overlay_Network_Bringup/04Deploy_the_vBond_Orchestrator/0...
Hello All, I am interested in a feature that is a part of the Cisco 819 HG. Namely the GPS feature. I am curious if the GPS, once enabled, can be tracked by position and/or coordinates? If tracking is reported in some type of syslo...
Hello,I have a Cisco ASA5505 with an inside Vlan1 and an outside Vlan2.The outside interface has the address 10.0.0.2 and my router (an Orange 'LiveBox')has the address 10.0.0.1 connected with an Ethernet cable.The inside interface has DHCP from 192....
Hello,I want to buy ISR4331-SEC router with additional modules - SM-X module with 6-port dual-mode GE / SFP and 2 port Multiflex Trunk Voice/Channelized Data T1/E1 Module.I know that ISR4331-SEC router have 90-days standard warranty. Specialists from...
I have a requirement to setup wol in an environment where there are about 8 sites all connected on a private MPLS.Each site has 20 - 50 PC's on it. I have been asked to configure the Cisco equipment to allow from a single place the...
Hello.I need to configure output service policy on SVI interface on Cisco7600.I create config:policy-map Customer1-OUT class Customer1-OUT police cir 3145728000 bc 31250000 pir 3145728000 be 31250000 conform-action transmit exceed-action drop vi...
Hi All,When Configuring a Sub-Interface In a Router, The Number That Can Be Assigned To It Will Be Within The Range (0 - 4294967296), Which Means That The Range Is Represented By a 32 Bits, So My Questions Are:1- Where Are Those 32 Bits (Ethernet Hea...
I'm trying to configure a Cisco 1941 to use a cell network with a EHWIC-3G-HSPA+7 card It auto generates the following command:chat-script hspa-R7 "" "AT!SCACT=1,1" TIMEOUT 60 "OK" Most cell configs I've seen use a chat-script similar to the followin...
Dear community helpers, Our ISP provides multiple static IP addresses from one source cable, we want it to be split into two cables, each one has separate IP address, plz refer to the attached diagram: I want to know how to configuration this. Any on...
Hello everyone,i have a problem with a pair of 3850-48XS-E (stacked with stackwise-virtual).IOS-XE Version 16.6.5. The 3850 is used as a distributions switch with two L3 connection (each with two 40GB interfaces in LACP channel) to the backbone (back...
Hi all, My goal is to be able to ping any of the loopback networks from any of the routers. Each router is in it's own AS and set as a neighbor of Router1. I can ping between Router0 and Router1 and between Router1 and Router2, but I can't go all the...
