Hello. I'm having an issue with routing when it comes to a non-vrf to vrf. on router1 i can ping and traceroute using the VRF with no problems to the destination subnet. on router2 it will forward the traffic to router 1 but then just dies there. ...
Forum Posts
Resolved! cisco isr 4431 router
Hi, How to configure 2 different ISP on single CISCO Isr 4431 router, as well as palo alto 220 firewall and cisco 2960 xr series switch.
Resolved! Interface Embedded-Service-Engine0/0??
Hi All,Sure this is a simple one. New to the 1900 series routers, have a 1921 with IOS 15.1. Noticed that there is a standard interface labeled Embedded-Service-Engine0/0. Can anyone advise what the purpose of this is? Cannot seem to find any detail ...
Hey everyone, Just wanted to run this out there to get some additional opinions and see if I was missing anything: I am looking at possibly deploying OTV w/FHRP isolation (via ASR1ks) across two data centers and removing the stretched layer 2 fabr...
Hi all, Dealing with a bit of a strange issue, hope you can help me understand it. The image below shows the topology. Please note, OSPF are is limited to area 313, I have some design constraints. R4 is redistributing a static default route into E...
Resolved! Cisco ASA 5506-X routing without NAT
Hi, I have a configuration I have previously used on ASA 5506 firewalls, which now no longer works (version 9.6). I am trying to make one single host accessible to 7 other networks. Therefore, I configure all 8 interfaces with an IP, and create a...
dear all i have internet problem and after checking with isp they replying me with below email ...i need to know which line is abnormal and i can know from it that packets drop and network slow? Dear Sir, Please be informed that, after investi...
i'm asking about the order of operation when excuting both under eigrp
Hello everyone, I want to say thank you in advance for any help that I receive. Lets start out by saying that I haven't configured anything Cisco in about 6 years, so I am rusty. I dug out an old 2600 Router as a refresher, and something to play ar...
I have an interesting issue. There is latency between a Cisco 2921 Router and its internal switch module installed in it, in my network. We have many of these 2921 routers but this one is the only one with this issue. The way we set these up is, th...
i have question i am looking for this ios c3560-ipservicesk9-mz.150-2.SE1.bin do not have a services contract but also no longer supports
Resolved! Alternative to Allowas-in xx
In a lab I was comparing Cisco's BGP implementation to some other vendors. If We have a customer with 2 locations (New York and Arizona), connected via a L3 IPVPN (MPLS service provider) we would be running BGP from the customer AS (at each location)...
Hi All, Please let me know the ways to upgrade the IOS in routers and switches without TFTP server. And if we want to do it remotely.
Resolved! QoS and DMVPN
I have a hub-spoke model using DMVPN. I have created a spoke QoS policy for each remote site to make sure that certain traffic gets prioritized over the tunnel back to the head-end router. However, I am a little confused about what kind of policy I...
New IT Admin for company and I've been tasked with configuring a Cisco Catalyst 4510R+E to replace a stack of 8 Dell switches. The previous IT admin had started the configuration obviously, as I have connected via Console and get to a prompt, but wh...
