Routing and SD-WAN

Hello,I am using a ISR4351 Router and want to configure a little bit of security. My question is, does it make sense to configure an ACL to an interface and also put the same Interface into a Zone for zone-based FW configuration? What takes preferenc...

Morning, Model in question is  24 ports 1Gb Ethernet Cat5/6  and 4 10Gb X SFP ports. This is my first time trying to apply a temporary licence.. The device was handed to me with the 24 1 gig ports working on the device but when I try to get a tempo...

I there a way to configure the Cisco 819 to Switch between primary WAN-1 interface GigabitEthernet 0 and Backup WAN-2 on cellular 0 interface ? On this router I use EIGRP Tunnel and Ip-Sec tunnel too. I tried IP-SLA but doesn't work at 100% at the ...

Folks, I wanted to cehck out difference between the Cisco ASR 1001 vs Cisco ASR 1001-X in terms of hardware limitations and licenses. Are both the routers IWAN capable? If they are IWAN capable what feature differences do they have as compared to th...

Hello How can i solve the below error *Jan 19 01:36:50.859: %BGP-4-BGP_LABELS_NOT_SUPPORTED: BGP neighbor 2001:DB8:100::171 does not support sending labels thanks all

Hi I recently changed the priority on the standby router to be (120) higher then the primary (110), which should have changed the traffic to secondary, but what happened was traffic was being sent on 1 link and received on the other. can I get an ex...

Hi, I'm Tom and I'm a network engineer.  I have a few questions about configuration, more specifically for static route redistribution filtering. I ran across a configuration similar to the following and would like some help in examining it.  I'm con...

Hello, I am looking for some suggestions for PBR / failover between multiple sites running Cisco and Juniper. I have three site A, B and C I have attached a diagram showing how the sites are interconnected. * All three sites running OSPF internally...

Hi All, I'm working on Cisco ACI at the moment, as you know ACI doesn't support EIGRP authentication at the moment. The ACI leaf is currently connect to the Nexus7K switches where the EIGRP authentication enabled at the global settings. One of the a...

Hello I have a isuee with a spoke router connected in a DMVPN network with GRE tunnels. The router is connected to 2 ISPs, I want to use the router to connect to the Internet or to link to other corporate nodes. I have tested the connection with NA...