Please pardon me if my question is dumb as I am just new to BGP routing. I have our HQ Routers 1 & 2 both running OSPF on area 0 with Partner Routers 1 & 2. ( See attached diagram). The same HQ Routers 1 & 2 also run eBGP with our branch routers BGP...
I are currently operating our devuce with no default-version set, but there is no impact on traffic, and when we reboot the equipment, it starts up with the expected OS version.Is there any problem when upgrading in the future?I checked the Upgrade G...
I am running OS Install for Cisco SD-WAN and executed the following command request platform software sdwan software install bootflash:isr4300-universalk9.17.06.05.SPA.binI checked if the files were extracted to bootflash, and I can see them wit...
Hello, I keep observing the following in router logs, I have removed BFD config and the BGP timers, but the BGP session keeps flapping, any idea what else I can check. Jul 9 08:46:11 router.id rpd[8119]: %DAEMON-4-RPD_BGP_NEIGHBOR_STATE_CHANGED: BGP ...
HejI am planning to deploy Inband Management plane protection to our ASR9000 series devices. I had a few questions1) Can I configure Loopback interfaces for management plane protection. Is it only for physical interfaces or subinterfaces that belong ...
HiI need help configuring L2TP with IPSeC on a Cisco router connected to an ISP via PPPoE. This way I can configure Windows PCs to connect remotely. Do you know of any sample configurations I can test in a lab? I appreciate any help you can provide.
Hi.I have tried the following configuration but when I use a named ACL it does not allow me to configure a distribute list, but the numbered ACL does.R5(config)#ip access-list extended test R5(config-ext-nacl)#deny ip host 155.1.0.2 host 150.1.9.9 R5...
Hi Cisco Community,I hope this message finds you well.I’m currently working on a network configuration where I need to route traffic for specific URLs over Direct Internet Access (DIA). I would appreciate any advice or best practices on how to achiev...
Hi Everyone. I am integrating SD-WAN Manager to Secure Access through group policy, the firmware versions has been followed correctly and established a tunnel to Secure Access and its connected. The SD-WAN Manager tunnel dashboard says that the tunne...
I'm trying to build an SD-WAN recently, but VMWare policy has changed, so I don't know what products to use. I wonder if it's okay to use VMWare Standard products. For your information, our company has fewer than 500 employees.
I have a question about the cisco SD-WAN licensing model.I know there are several tiers (0-5), and for example the Tier 1 gives 200 Mbps nominal and 400 Mbps aggregate bandwidth.How can I monitor/detect/calculate if I'm reaching a license limit? Will...
If static routes are redistributed into SW1 RIP what will happen if link between sw1 and sw2 fail? what can be done so that if sw1-sw2 link fail sw3 would advertise sa static routes?
Hello all!I have a test VXLAN environment, that is currently hosting 4 networks between 4 9k's and everything with VXLAN is working great. I added 2 firewalls, that my 9k's connect too and get their default routes from. With that, I also added 2 DMZ'...
I have a C9300L as the Core switch where I have the interface vlans configured for the L3 and I have some C9200L as the access switches for the end users.In the Core C9300, I have the DHCP server and the pools configured and some users are not receiv...
Hi, I have an issue in vManage, When adding Template to cEdge, the following error appears: vManage version: 20.9.4.1
