Routing and SD-WAN

Hello, We're dealing with an issue right with Comcast.  Our options for receiving are: default route, default route + full routing table, comcast customer routes + full routing table, full routing table.  We're using SUP720-BASE supervisors (I know I...

Hello All - This is a conceptual or Non-Cisco product question. Hope you can help me to get this best industry practiceI am doing a Capacity planning for the WAN Link Bandwidth. To study the last month bandwidth utilization in the MRTG graph, i am se...

Hello all,I have a Cisco router configured as HUB using NHRP - DMVPN, and I need to configure a Huawei router as spoke.Is that possible?Thank You   

I am getting the following error after a circuit upgrade from a ISP CSME to a ISP ASE (Switched Ethernet). The remote end is the one that is producing the error below. I have posted the config on the Catalyst switch. They are 4510's with Sup7 engines...

I segregate my  routers into different syslog groups,  to that end I have setup "logging facility local6" on my Cisco 2851 Internet router. But I am still getting the following messages in my Syslog2015-04-11 00:32:03 Local0.Alert  localhost FA: syn ...

We can use the command below to display total traffic:sh int port-channel 123 counters etherchannelIs there any way to display average traffic? 

Hello,we have 2  switches in stack, last night switch 2 was removed from stack and got rebooted and again it got back in stack.Switch -2 entered  into the provisioned mode for certain span of time. snap shot is attached .Apr  9 02:36:25.266 IST: %STA...

Need help on BGP where seconday router interfaces,RX is not happening.Site has two MPLS links which are in active active mode, but on one of the router Rx load is not happening.Please advice  sh int g0/0 on primary link Input queue: 0/75/0/0 (size/ma...

Hello All,I am facing some issue on BGP.I configured BGP on cisco 1905 but /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-pri...

Hi, I wish to implement DMVPN usning single hub, single router with dual ISPs and have 10 remote spoke locations connected single ISP.Want to create two tunnel interfaces from each spoke, one is primary (ISP-1 at HUB) and another (ISP-2 at HUB)is bac...

We have 50+ sites on our MPLS network. All are connected quite successfully and all have a completely individual private AS number eg router bgp 65001We are about to bring a new site online and our telco provider has given us the details but this tim...