Routing and SD-WAN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi All, Currently I have a 5525-x with a public IP on the Outside interface connected directly to my ISP and the ASA is doing all the NAT translations, VPN and firewall requirements. We are now getting a second internet connection to a different ISP ...

Fraser010 by Community Member
  • 1569 Views
  • 8 replies
  • 0 Helpful votes

Current config: Port 0 is outside (VLAN 2 - going to ISP) and Ports 1-7 are inside (VLAN 1 - going to internal LAN devices). The ASA version was upgraded to 8.3.1 a few months back and everything is working properly. However, we are now wanting to ad...

hi, Could you please help me on the below issue? We have seen that sometimes few switch is reaching to waring thresold (58 Degree).My point is that can we confiure the thresold limit ? Has the switch any internal protection to avoid overload on hardw...

Resolved! BGP with two ISP

Dear All,I am trying to achieve below scenario, need your expert suggestions and help. I have two Sites A and BSite-A (Head Office, Datacenter)Subnets at Site A = A.A.A.0/24, B.B.B.0/24, C.C.C.0/24, D.D.D.0/24 Site-B (Remote Office)Subnets at Site B ...

Hi All,Which Image should we need for the below model router 2951 to support 4 Byte ASN number ?CISCO2951/K9Cisco 2951 w/3 GE 4 EHWIC 3 DSP 2 SM 256MB CF 512MB DRAM IPBPWR-2921-51-ACCisco 2921/2951 AC Power SupplyCAB-ACSAAC Power Cord (South Africa) ...