Routing and SD-WAN

hiI have a Router 7600 connected to port 1 to Switch1 and I want to implement high availability on the same router interface connecting to another switch2 other replicating the same settings I have on port 1, but I do not want to implement HSRP time ...

 Hi All,I have a cisco router and access point and two PC's.  Access Point is connected to the router. ISP is connected to the Router. I have tried the configuration in packet tracer but systems are not getting IP address from access point. Something...

Greetings, I'm dealing with an issue on a router running IOS Version 12.4(24)T4:The router has an IPSEC tunnel with another router (non-cisco) at another site and the tunnel is working fine.My problem is that hosts behind this router cannot route to ...

I'm running into an Qos problem.  I noticed the Qos on the routers at my company needs to changed. It looks like the Meta traffic is merging into the voice traffic. The Qos policy is not applied to the serial interface on the router.  I have recommen...

Hello everybody,I have an issue understanding the difference between 3945 and 3945E from VPN support perspective.If you check this link here:http://www.cisco.com/en/US/products/ps10536/prod_series_comparison.htmlYou will see that the 3945E doesn't ev...

We have small to medium size network, with a cisco WS-4500X-16 as a core switch, a Nomadix that does NAT'in, DHCP Server, and layer two switches.The management VLAN has an access-list applied to it, to block certain traffic and allow the rest. There ...

I have a ring of 4 routers which I need to have 2 separate ring on the same devices. Thinking of running 2 different ospf processes. Is this the good practice? Thanks for the input

Greetings,I have a cisco 1841 with is attached to the internet via ethernet. From within the config on the router, i can ping servers on the internet.However, from within the config, i can not perform a trace from the fast ethernet0/1(private side) t...

Hi Everyone,I've been asked to configure a site to site vpn on a cisca ASA 5505 and i've been asked to use a NON-RFC IP address/network because the other end using the 192,10,172 network on some of their devices. i went online to one of the subnet an...

All, I'm in a bit of an odd situation.  I had to change over the primary nameif on a Cisco ASA 5510 running 8.2(5) DeviceManager 6.4(5) Currently everything works as intended (natting, vpns, ninjas) except for internal access services including telne...