Routing and SD-WAN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Dear Sir,Please be  informed that am going to explain the issue which am facing my small organisation.I am working independently in small company and we have a Network infrastructure in our domain. Since long back its working good, but recently 3-4 d...

I am having Cisco 1900 router.  For configuration purpose I have installed Cisco Configuration Professional software. I have connected the router using USB cable. I could configure the router using hyperterminal on the same PC.But when I run Cisco Co...

If I am using the bgp 'aggregate-address' command do I need a network statement?From testing, it does not appear to be necessary but is this good/bad practice?Below is my proposed configuration, any suggestions you can share would be appreciated.!rou...

brunop by Frequent Visitor
  • 1529 Views
  • 2 replies
  • 0 Helpful votes

Hello,I'm looking for some ideas regarding how we prioritise traffic into our MPLS WAN to and from our HQ LAN explained below.We have 2 Cisco routers working in HSRP.  The active router is a 1gb line and the standby is 100mb, inbound they then go int...

I have a Cisco 2801 router that failed to boot due to corrupted cookie table, it does not have a MAC address and some lines are missing compared to a working 2801 cookie. I tried to modify the cookie table according to the working one, but it still r...

OrigamiSS by Community Member
  • 1076 Views
  • 0 replies
  • 0 Helpful votes

We recently bought 5 x Cisco ASR 920-ACZ, The problem is, not configuring SSH, but when i connect for the first time it works fine.After 1 time connecting, and then disconnecting, i cannot connect the second time. I allready tried :ip ssh timeout 60 ...

Resolved! External Calling

Hi I'm trying to enable external calls currently I can call internally and receive external however I want to be able to phone out on one if not all phones connected to the network.Below is my current config: Building configuration...Current configur...

I have a 2811 with the following config; one outside interface connected to a T1, one physical inside interface (three VLAN sub inside interfaces) and a tunnel spoke in a GRE network. On the inside physical  interface there are three VLANs; core, LAN...