Routing and SD-WAN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Dear Team, I am planning to propose get VPN in our organization. We are running with 2 WAN links with the same provider,  however we are achieving load balancing over these links by using subnet based. Hence we are running with assymetric traffic rou...

jubair151 by Level 3
  • 389 Views
  • 1 replies
  • 0 Helpful votes

I need to create a site-to-site tunnel using one IP Address on my side.  In ASA only site-to-site tunnel this isn't a problem but I am bit confused on how I get it to work on the ISR side.  For example here is the commands in the ASA:global (outside)...

Hi,I'm just beginning the adventure with cisco - I bought a 877W, I configured, the internet works but only after the cable - wifi connection is detected by the laptop, but can not connect (yellow triangle)I tried several configurations but none was ...

marekpro607 by Community Member
  • 826 Views
  • 2 replies
  • 0 Helpful votes

I am having a problem with my VPN tunnel from ASA to ISR.  I just want to assign one ip on my Cisco ISR side to 192.168.96.48 and allow it to only access 192.168.96.101 & 192.168.96.102 on the ASA side.  I also need this tunnel to be bidirectional.An...

Hello again, having problems with the permit and deny in my router, my problem is I have managed to put this my CLI but i am able to ping from 192.168.10.3 and 4 to other networks when it should be blocked i don't understand can help someone me?This ...

Hello, We have a public ASN and a public IP prefix (/22)We have 1 ISP on one router, we are going to add a new router (R2) to add more security in another datacenter with another ISPWe will use iBGP between the 2 router (we have a dark fiber between ...