Routing and SD-WAN

Hello everyone,  I want to ask a question, is it possible to have a load sharing between two default routes? Let's say I have 1 router with 3 interfaces.- int f0/0 connected to ISP1 - int f1/0 connected to ISP2- int f2/0 connected to LAN segment Righ...

Recently just attempted to setup my 1800 series router with charter cable internet. Everything seems to be set up correctly but we can't ping anything outside of our local network.  I'm just curious what the first step to take in resolving this is. I...

 Hi experts,The question is if a L3 switch is able to receive a WAN link which is Ethernet, at the same way than a router? 

Hello Everyone.I have  a Cisco 867VAE-K9 VDSL router with what looks like a good VDSD configuration for NZ.The PPPoe connections establishes ok but I can only access some NZ sites, no International sites.The connection stops altogether after about fi...

DearsWould like your assistance please regarding belowIs there a similar command to JUNOS "next-table" in Cisco ?Would like to do MPLS VPN route leaking between 2 vrfs. route-targets can not be used as I am only receiving default route so leaking def...

Hi,we  got 2 public ip network from our ISP. This ip networks are from different class.  Let assume,195.130.15.144/29   gateway 195.130.15.140185.185.15.64/27    gateway 185.185.15.65this two public ip network.  I am already using 195.130.15.144/29 n...

Can anyone help me with this Router 1941 connected o lan on port 0/0 and to fiber modem on port 0/1 with static address. I cant get internet acess throught cisco 1941 to work Best Regards --------------------------------------------------------------...

Hi, Can anyone explain about VPLS?VPLS still required rd and rt on PE routers?Thanks,Nivetha

Hi All, I have router with 2 Connection.1) IP Transit from Tier 2 Provider2) IX - Local Internet Exchange for local peeringI'm receiving full internet route nearly 500k+ entries. I also have few local peering through IX connection to local telco. Now...

Hi,I just want to ask about bandwidth points on cisco 7206VXR with NPE-G1.What will happen if bandwidth points oversubscripted on one of the PCI bus? This is the sample:===========PCI bus mb1 (Slots 1, 3 and 5) has a capacity of 600 bandwidth points....

I made an earlier post and I probably made it sound more complex than it should, hence, here is a simpler post.I used Cisco's RV082 router and created a successful VPN tunnel connection site-to-site.My machine in local group is able to ping any of th...

Dear allI have one Router (R1) running iBGP processs with two peering. I want to advertise specfic Network to R2 and others routesto the another Router (R3). R1 receives deafault-routes from both peeting.R1router bgp 65471 bgp log-neighbor-changes ne...

Anybody implemented before OER ? Can anybody sendme an example?  Thanks