Routing and SD-WAN

I have been working with so many clients and service providers and came up with a Cisco Quality of Service template that suits most of my clients. This template needs to be modified in little to accomodate your client requirements. I have captured tr...

Hello. I have router Cisco 3945 with switching module EHWIC-4ESG, IOS version c3900-universalk9-mz.SPA.153-1.T.binThe problem is that I cannot including switching interfaces (gi0/0/0 - 0/0/3) in created channel-group, that is no command "channel-grou...

>> area 0 authentication message-digestdoes this command makes that md5 authentication mandatory for the rest of the network segments in area 0 or just for the network connected to that particular router?

Hi GuysI have internet with to ISP providerThe First has ISP has 150 Mbps (1:1) and the other has 70Mbps (1:1)I want know if you could have a link (or some template) of configuration where use OER, when from my LAN network is leave 60 Mbps, 40Mbps le...

Hi allI have 2 internet routers from different providers, both routers are running full table and ibgp between themWe run ospf internally and I want to route to my 2 internet routers from my inside network, I want to allow the internet routers to pic...

Hello All,I want to configure IP sla for one of my WAN link so that when i get packetloss to next hop i should recieve a trap. The configuration below works only for one time later on i dont recieve any traps.ip sla 10icmp-jitter 2.2.2.2 source-ip 20...

I have query about BGP active state, please share your expert comments -    1. From Idle > Connect > Active = Here BGP stuck in "Active" state after connect state due to Source or Destination IP unreacable OR TCP port 179 Not permited/Filter on inter...

Hello,help me pls, how long takes bgp to install new best routes(FULL VIEW) to routing table if i reset my primary neighbor. I have second neighor with AS-PATH PREPEND. I need to know will be break in routing or not.

Hi i have a  WS-C4006 switch.It hasIOSCAT{System Bootstrap Version: 5.4(1)}.I need to upgrade CATIOS in to ciscoIOS.Can anybody give me the steps???thx

                   I am looking for a solution to test backup links for my routers, without having to shutdown primary link.... We are using primarily BGP and EIGRP protocols and most of our backup links are VPN tunnels. Other than using passive inte...

Hi, i am dealing with a network problem. Any ideas will be helpful.Thanks.    

Dear Folkz,I've 50 users in my lab., all of them are accessing internet via a NAT router., I want to get a report of internet usage per ip from my NAT router.? How can i do that..?  Is there any possibility any way??