Routing and SD-WAN

Hi,First of all I have to say that I am not a native english speaker. Apologize errors of any kind.On a 3750X, I am allowed on an output queue to set the value of Threshold#1 and Threshold#2 above 100% (up to 3200%).From all my readings I understood ...

I'm trying to configure HSRP on a pair of 2911 routers with Etherswitches and am having difficulties getting it working.  The symptoms are the following:HSRP shows as ACTIVE on both routersTrunk appears to be working as I can ping devices connected t...

Hi,One of our client having issue with their Oracle application.Whenever the oracle clients at a branch are filling the forms or making queries their queries and forms are taking 4-5 minutes to bring results.now the issue is the application team is b...

Hi Do either the EHWIC-VA-DSL-A or HWIC-1VDSL, allow finetuning of the SNR noise margin?  This is a useful feature on some VDSL routers/modems.

I setup port forwarding for a security camera DVR that I have.  I can successfully access the camera feed form the outside, but cannot view the camera from the inside using the DDNS service address that I have setup for the DVR system.  Is there a se...

I have a remote site coming up that will be on a site2site VPN until the MPLS is finished. The remote site is a 2921 router, the data center is an ASA5520. I am running ZBF on all the remote sites, my question is what zone is the site2site connection...

Hello everyone,We are switching over to TWC Ethernet handoff from T1 circuit at our school. We are using a Cisco Router 2611mx with two f0/0 - f0/1 interface ports.Our NAT is being done on our Cisco PIX506 and  is on the inside of our router. The ISP...

Hi,Is there a way to filter out routes I've learned from a neighbour via OSPF? E.G I'm learning a.a.a.a and b.b.b.b but I do not want to have b.b.b.b in my routing table. Thanks

I would like to share a 2 level QoS config first and then the same config using 3 level -!! Example 1!class-map match-any C-EF match  dscp cs5  ef!class-map match-any C-AF4 match  dscp cs4  af41  af42  af43!class-map match-any C-AF3 match  dscp cs3  ...

Hi. I have question concerning LDP timers. From Cisco press LDP has hello and holddown timers for discovery and the same timers for session maintenance. Using debug, I saw that LDP neighbors exchange two types of messages constantly:- helloes each he...

ip nat inside source static tcp 10.0.0.3 80 86.96.201.7 80 extendable

hey all.I have two routers connecting to two upstream ISP's...(Im an ISP myself) one primary one secondary. The two routers have the exact BGP configuration. i recently configured local preference on the routers with one set to 150 and the other at d...