Routing and SD-WAN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi,We have a Cisco 7204 G1 running c7200-advipservicesk9-mz.122-33.SRE7.bin and we're having a lot of difficulties getting a VTI working to a Cisco 2921 with adv. security.I've ruled out that the 2921 is at fault by successfully establishing a VTI to...

                   Hello, I have a question on setting up MPLS on a single T3 line. A client has contacted us to set up a 2951 at a branch location. There are 5 locations connected with MPLS.They will split off 4meg of the T3 for mpls. The rest of th...

Hi Guys,I primarily deal with security at my company but have been tasked with a routing/switching issue that is starting to give me a headache. I have a remote site that I need to connect back to the corporate network across a wan, (the wan will be ...

scanpatton by Community Member
  • 873 Views
  • 1 replies
  • 0 Helpful votes

Hi,Does ip default-gateway have any effect on a L3 device such as a 2811 router? I always thought that on a L3 device the default route would supersede any such command assuming it is accepted. We have a client device that cannot be reached for manag...

lcaruso by Level 10
  • 572 Views
  • 1 replies
  • 0 Helpful votes

Hey,The titie might confuse and let me explain here.I have 2 routers connect to 2 different ISPs for BGP. I have HSRP configured on both to form a failover redundant pair. However basing on Solarwinds, one of the 2 ISP link is loaded at the moment. S...

SIMMN by Spotlight
  • 974 Views
  • 4 replies
  • 0 Helpful votes

Hello Everyone,When do we use the following ospf commands?I've been working within GNS and it seems that ospf automatically recognizes, based on the media type, what the network type should be..So, I don't understand why these commands exist?1) Broad...