I'm currently studying BGP in the Cisco book. It's about the command: set as-Path prepend 222 221Where does 222 221 come from?In the network diagram I only see AS 100, AS 200, AS 300, AS 400.Can you help?
Forum Posts
I'm trying to connect server 2 from server 1 using port forwarding. Server 2 add server 1 ip 72.12.13.111 as dns record. I'm trying to connect using server 1 web browser to ya.ru:8080. How can I do that? Router 1 configure dynamic nat translation.I'm...
I'm trying to connect Server 1 web browser to to server2 using ya.ru:8080. Server 2 outside the and server1 inside. How can I do that using address translation? I think I have to configure both Router3 and Router1. Can anyone help me How can I do tha...
Anyone seen this error before? RP/0/RP0/CPU0:Feb 2 22:49:49.944 UTC: locald_DLRSC[302]: %SECURITY-PKI-6-ERR_3_PARAM : Crypto engine decrypt failed : 'Crypto Engine' detected the 'warning' condition 'RSA public key decryption failed' 1116083200 Th...
I was wondering if anyone has come across this before.I have just started my course in cyber security and the first 2 activities aren't working the same as the videos online show, it seems whenever I use any application within the desktop (web browsi...
Hi I have the following scenario and little confused about the technology and topology that need to be used RTR1 and RTR2 are the service provider routers (CE), and the provider informed us that they have an active-active connection via BGP.The quest...
Hi, what if during a migration you need to rollback the SDWAN config to the previous non-sdwan config. (Note that I'm not talking about the IOS software, just the config). Just detaching the device won't help as the SDWAN-config will stay in place (a...
Resolved! Type 5 external LSA remove
Hi I've written bad IP address as I redistributed the loopback interfaces into OSPF. I want to remove the IP address from ospf database but the command no network A.B.C.D wildcard mask area X under the router ospf subinterface has no effect. I wa...
I have a small SD-WAN setup for a company with two "DC" locations using SDCI/Cloud On-Ramp to my main AWS subscription and two remote sites that connects via the SD-WAN to the SDCI to access the workload. I have two test AWS subscription that are not...
Hello,I have a 3825 router with a dead console port. Plus, I can't access to CLI through ethernet port because they admin down after a reset. The router boot and after that, ethernet port are disabled.How can I acces to CLI in this case ?Thanks for y...
Resolved! EIGRP Unequal Load Balance
Hi everyone,hope you can help with EIGRP unequal load balancing in a Catalyst 3650. I have a system where I need to send the traffic to reach the 10.1.40.0/24 via the vlans 4084 and vlan 4087. Due to the metric, the vlan 4084 as the lowest FD and vla...
Hi Guys, can somebody help me understand why this wan edge does have outbound ipsec connection to another wan edge to mpls even if the bfd to mpls is down. BTW, I intentionally did not put route from mpls network to internet just to simulate the priv...
Hi,I'm unable to ping from the R2 router IP address 172.16.0.1 similarly from the R5 router as well. I configured the OSPF and static route in the R12 router and redistributed it. R12 ROUER interface Ethernet0/0ip address 172.16.1.104 255.255.255.0du...
Hello everyone,Currently, the FPR equipment and C9300 equipment are connected with an optical cable.It was a cable that had been in good use before.One of the FPR2130 devices failed and was restored to its original state.But the problem is that the d...
Dear Engineers, Hello, I am trying to figure out how to apply ipbasek9 license feature permanently.Furthermore, when I run 'show license', I receive the following information for ipbasek9 under Index 4:Router#show lic*Mar 16 06:47:23.752: %SYS-5-CONF...
