Routing and SD-WAN

Hi folks,This is a repeat question can't find the original thread but did find some other threads asking a similar question. Most pointing back to some configuration notes or another thread that describes a similar configuration of which neither quit...

Hi All,I want to know if the Cisco 2900 series can do UC without having to buy any other hardware.I read through the 2900 series datasheet, and i can understand it does.But will want to clarify if i do not need any other hardware except the Unified C...

Hi,We have a client with a Cisco 887 router using it on a Plusnet ADSL service.Internet browsing and all other functions are working as they should, except outbound emails.  The client is using a private hosted mail server for their emails and can re...

I am getting ready to deploy IP sla with policy based routing. I feel pretty confident that my IP sla and PBR configuration is correct, although I attached their configuration to the bottom of my post. My question is with the NAT statements; as long ...

Why can't I use the interface commands:  tunnel bandwidth transmit -and- tunnel bandwidth receive     commands on the below platform and IOS? Router#sh hardwareCisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.2(1)T1, RELEASE SOFTW...

Hi ,could you people suggest on below.We have two offices in differrent locations and these two offices  has connectivity through MPLS cloud.For exampls :Location A  advertising the below NW in MPLS10.10.0./2410.20.0./2410.20.0./24Location B advertis...

Good morning at all, I m new in the forum and I will thank everybody can answer me at a question on route summarization.I don’t understand the difference when to apply the ip summary-address on interface or when to apply at protocol level. If I apply...

Hi,I am new to BGP, so need some help with BGP routing.all our 10 sites are connected via MPLS. i have dedicated link between two sites which are in the same geographical area and is backup link between these 2 sites only.I want to use this link as a...

Hello,I have a large access list of host networks that I wish to deny on a Cisco 1941 ISR. The list is about 9000 lines of subnets, but I'm sensing that an access-list this large would make the router grind to a halt.This deployment uses the zone fir...

will the VWIC-2MFT-T1-DI card allow me to connect an ISDN PRI to my 2600 series router, looking to use the router as a ISDN network emulator.

Hi guys,  i am currently having an issue with telnetting to a router on my network.  The router is working fine, and is contactable.  I am trying to telnet to the router from a 192.168.10.xxx subnetHere's what ive tested so far:I can ping the router ...