Routing and SD-WAN

Hi Colleagues,We have seen the following message on a  CISCO 7609-S (12.2(33)SRD3): %FABRIC_INTF_ASIC-4-FABRICCRCERRS: Fabric ASIC 0: 239 Fabric CRC error events in 100ms periodExplanation (Output Interpreter): The Switch Fabric interface Fabric inte...

Hi AllHope someone could shed some light on thisI have a cisco 2811 router that is runing a ipsec VPN between two of our offices and is connected to a 10MB lineThe problem is it seems the router cant encrypt the data quicker enough for the line speed...

In response to my post in https://supportforums.cisco.com/message/3446905 I am settin up a LAB to test multicast in DMVPN.I have three routers R_HUB, R_UNICAST, R_SPOKE, (see attachment)R_UNICAST router (unicast cloud) is connected between R_HUB and ...

hi i have an ASA 5520 version 8.4(1)the wan interface is 216.41.115.33 and the internal subnet is 192.168.1.0 /24what would be the exact nat command so users on the internal subnet can access the internet ?e,g,object network internal_subnet nat (Inte...

HI Expert,I need your helps for how to redistribute connected networks using route map in ospf.if any one have any document  or link regarding it, Pl's share it.Thanks in Advance.Regards,Surya

Dear all, intra-confederation labs -    Ibgp router (R1 ) - propagate updates packets to intra-confederation neighbor (64512) and 64512 - member as sending notification errors to ibgp router R1 - with Malformed AS_Path    R1   neighborship going down...

Hi Gang,I'm in a bit over my head in trying to route WAN and LAN traffic via the correct interfaces.  I have two remote offices, one north and one south, connected by a dedicated line between each other and one dedicated line between the north office...

All,I have mpls label propagation disabled on my PE routers (no mpls ip propagate-ttl), but I'm seeing the very last hop's label and can't figure out why. I attached a topology diagram. (8.8.8.8 is LO8 on R8 across the mpls network.)R7#trace 8.8.8.8T...

Ive got two customers that are getting a providers XLAN product that is essentially a point to mulitpoint layer2 bridge.In the early days Frame-relay used a similiar type of setup and used fram-relay class maps to solve the issues.How can I setup QOS...

Hello ALL . I am troubleshooting an MPLS VPN qos issue for one of my customer and we are actually discussing on the integration of their packeteer packet shapers on each eadge of the Network . The topology is as follow :Customer lan --------- custome...