Routing and SD-WAN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

I know I'm forgetting something stupid.. Have the following configuration:router A:int g0/0.79description to switch A g1/5encap do1q 79ip address 10.27.79.24 255.255.255.0no shutswitch A: int vlan 79nterface Vlan79description SWITCH MANAGEMENT VLANip...

w951duu by Level 2
  • 934 Views
  • 2 replies
  • 0 Helpful votes

Hello Community,I am about to purchase a Cisco Catalyst switch. I am not 100% sure if it can do routing between my 4 different subnets.I looked throught the product guides on cisco.com, I just want to make sure that someone out there has used these s...

imanco671 by Level 5
  • 2663 Views
  • 10 replies
  • 0 Helpful votes

Hi All, Can you all please help me to understand a few concepts based on below toplogy        R1 ----------172.17.70.0/30------------- R2         |                                                |172.17.70.8/30                   172.17.70.4/30       ...

Hi,I am reading now a little bit about NSF and NSR. NSF is actually graceful restart or am I wrong? It waits first when a RP is shutdown and after the holdtime it clears the neighbor relationship?NSR is a feature that does not tell the neighbor that ...

Hi,Very recently, we had up graded our Leased Line's B/W from Serial 2Mbps to FastEthernet 4Mbps. Router A is Cisco 3845 and Router B is Cisco 1841.We had changed the HWIC's cards also to HWIC-2FE on both ends as per our requirement.IOS also upgraded...

Resolved! IP NAT

Hi Folks,I have a query on NAT that I hope you can help with.Have static nat configured on a router. The inside interface is onan Ethernet interface and the outside on a dialer interface.When a packet transits the router NAT occurs however when I loo...

pbelletty by Level 3
  • 939 Views
  • 4 replies
  • 0 Helpful votes

Background Info:I have a customer who has a pair of 3825s with DS-3 cards. They have remote sites with 4 pvcs per site. Two of the PVCs are running in one VRF and the other two are running to the other VRF. OSPF is configured so that one pvc from eac...

Hello We have configured a Router cisco 7206VXR (NPE-G1) as PPPoE Server and a AAA server remote. We want to send the attribute 31 Calling-Station-ID (MaC address client) to the radius, but is not possible.In router i have configured :  radius-server...

GRTO by Frequent Visitor
  • 735 Views
  • 0 replies
  • 0 Helpful votes