Routing and SD-WAN

I have a question about a tunnel interface is that the sources and destination IP address or the global private IP address?

Hi,Recently we have installed 10G LAN&WAN modules in 7609,7606 routers and 6509 Switches .we have inserted 10G LAN Module module in 4th slot of 7606 router and later we removed the 10G LAN module from the slot 4 but the interfaces still showing in th...

I have a 7200 series router with PA-POS-1OC3 module. I would like to confirm if this can support the ATM link.Can anyone please help on this?

Dear all,What is the load balance method of 3750 port channel ( by source ip , or by source mac ) to diver traffic to paths?I have tried to use 10.242.104.101 and 10.242.104.102 as source ip, it will travel to the same link (G0/1) within one port cha...

Hi All,I need your confirmation on this set-up that i'll be attaching. I am planning to implement this set-up, ECMP from the Core to the Internet Edge with ASA. From the edge default route will be injected pointing to the Internet and route redistrib...

Hi,Can someone share the Heat Dissipation for ASR 9010??Rgds,Partha

Network is growing.I need a tool for SNMP provisioning.A control panel where I can enable, disable services on switches etc.For example set rate limit, ACL and so on for customer ports.I have mostly Cisco, but also Procurve and Zyxel (enterprice).I w...

hello all,i just managed to config the Cisco 877 and send it to my client,when the client connect the router from his location the router can't make VPN connection to my HQ office,i can connect to the router using the external IP adress,i tried to re...

Dear Team, We have 3750 and 4510 switches and in both we run Q-n-Q but we observed looping/Broadcase Storm we already run STP on 3750 end and this is corporate branch but 4510 its difference branch where we run q-n-q technopoligy please let me know w...

Trying to connect two Cisco 1941 routers with VWIC2 1MFT-T1 interfaces on point-to-point T1 (No Voice). Can someone provide me with a sample configuration, this is what I have so far, but I'm not sure if it's correct. Do I need any specific informati...

I recently installed a WIC 1DSU-T1-V2 card into a 1841 router to add to a multilink bundle.  I inserted it in Slot 1 and powered up the router and there was a new serial interface showing in the config automatically as s0/1/0.  I was able to get it s...

Hello,I will now try to ask here I have some problems with stability of my OSPF session between 3 devices. the topology is simple:cisco7200 --- catalyst3560 --- cisco2600the cisco7200 and catalyst3560 are speaking MTU 1546 (because of QinQ and MPLS)c...

Dear expert,I have one issue reagrding route advertising of BGP to two ISPs. There is one network 192.168.128.0/23 which I would like to announce to ISP-A. However, ISP-A has already had this network (192.168.128.0/23) and ISP-A sends me that route. ...