I've seen many discussion on this, I repeat the procedure but still does not work on my project. 1. I tried to configure Router0 as following: - FastEthernet 0/0: 192.168.1.254 255.255.255.0- Fast Ethernet 0/1: 192.168.10.2 255.255.255.0-...
Can VRRP virtual IP be a different subnet IP from the interface IP?
Hello all ,Lets suppose that we have directly connected routes ,We want to redistribute them into the ospf process except for just one subnet.How can we accomplish this ,I think that we can not use route filtering cuz they handle type 3 LSAs ,Here we...
Hello, I have a problem, I have a modem/router IP 192.168.0.1 that is connected to a Cisco router 10.10.10.1, we cannot get internet on it.
Hi,I'm trying to implement IP SLA on router which should check internet connectivity via ISA server, which is proxy. I tried this two configurations:!ip sla 10 http raw http://www.cisco.com source-ip 192.168.5.1 version 1.1 proxy http://192.168.255.2...
Dear All , Kindly help to me understand the configuration. router bgp 65005bgp log-neighbor-changesbgp update-delay 5network 10.239.55.113 mask 255.255.255.255neighbor 10.102.86.185 remote-as 9730neighbor 10.102.86.185 description *** EBGP BHARTI **...
hello everyoneI have setup a lab scenario to practice static routing, but I am only able to do ping on 122.27.27.35 from R1 and 122.27.27.37 from R4, and not able to ping the rest of the network like 143.32.32.122 from R4 and vice-versa.can you plea...
For the past 5 years I have had AT&T business fiber connected to my C2901 router and its perfect. The only problem is that I work from home and the AT&T service costs $605 per month. Now T-Mobile Home Business internet service is available for $50/m...
Hi All,I always confuse on the difference b/w the IPSEC over GRE and GRE over IPSEC as both the functionality looks same to me but not finding the difference.Please help to understand this.RegardsSuresh
I currently have 2 3725s multi-homed to 2 different ISPs. Everything's been working fine, but recently one of the ISPs had me change their session for a hardware upgrade. They require that I NOT send the full routing tables from my router, but they c...
Hi everyone,Why do we need IGP (OSPF/EIGRP) before we run iBGP ???Regards
Hi, I have two questions with this particular device. 1. Can i downgrade directly from 17.6 to 16.9.x? If so what are the requirements. 2. For me to support DMNR, do i need to have appx license? Your answers will be greatly appreciated
Hi, I'm currently studying CCNA and I'd like to clarify something regarding the LAB which I'm working on. Going straight to the point, I want to establish connections for Vlan 10 and 20 across the the network. however I have no idea on how properly s...
I have kind of an odd one that TAC hasn't been able to really figure out yet and I am hoping someone can point me in the right direction. We deployed a new Catalyst 9300 switch stack and two new Catalyst 8200 routers in one of our offices. This is th...
I have an ASR 9000 cisco router where I am trying to move the existing global routing table configuration into a VRF. so the current configuration on the device is as follows: interface Bundle-Ether1.200ipv4 address 10.10.10.2 255.255.255.0load-inte...
