Routing and SD-WAN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

HiI am doing a comparative between cisco and sonicwall routers.  Which router would better fit me? i need it to support at least a 20MB internet connection in a datacenter and has to have a firewall included.I was thinking about a router 1941. What d...

Hello all, I have a situation in one of our offices and I am not totally sure if its a problem or how it's even occuring - I was hoping some one here would be able to point me in the right direction? We have an office that consists of the following: ...

After a series of power outages, our Cisco 2821 router wont boot.  There are no LED's lit on the front panel.  (The LEDs in the back near the Interfaces do light up.)  When I connected a console cable and power cycled the router the message "RECEIVE ...

jhdoebling by Community Member
  • 1537 Views
  • 1 replies
  • 0 Helpful votes

I need design a edge wan router for QoS for the main office in which concentrate 30 remote sites,  the QoS polices are very specific, so whitch are the guide lines to choose this router?Thanks in avance for your help

juankcs85 by Level 3
  • 1438 Views
  • 7 replies
  • 0 Helpful votes

I do some development for a local company and support, but there is one massive problem with their network.The person who initially set it up, cannot be contacted and things are pretty much a mess, they have one wifi tower, and all the traffic from r...

Heinrich09 by Community Member
  • 671 Views
  • 1 replies
  • 0 Helpful votes

We have two Internet circuits w/ Verizon Business.Before we signed up, they promised we'd be able to utilize both of them in active/active fashion.After the circuits were turned up, they refused to turn on bgp multipath, citing some BS policy, so we'...

huangedmc by Level 6
  • 2292 Views
  • 4 replies
  • 0 Helpful votes

Hi!Because of poor CPU performance and restrictions of applying QoS policies (including shaping and policing) on the VLAN interfaces created on integrated L2 switch ports, we have to change our Cisco 1811 routers in HQ to 2921 model.The latter has on...

Hi All,Below is the config has done on my 881g but the dual NAT failover is not working.I have a easy vpn over NAT (easy vpn firewall: 10.10.10.2 behind the router).Tested like below....1. After completed the config, I shut down the FastEthernet4, cl...

jopetik09 by Level 3
  • 1139 Views
  • 5 replies
  • 0 Helpful votes

What I would like:Internet-----------887va-------LANMy setup:I have a adsl setup from my ISP (TDC) and I would like to use my 887va as modem instead of the supplied Motorola Modem.I have the technical info on the connection: VPI = 0, VCI = 101 and RF...

softwalker by Community Member
  • 1208 Views
  • 1 replies
  • 0 Helpful votes

Hello Dears,Does anyone have an idea, if the  7600-SIP-200 supported in VSS mode or not ?I have configured to Cisco Catalyst 6513 as VSS, both of them have the  7600-SIP-200 module, before converting them to VSS I was able to work with the  7600-SIP-...