Routing and SD-WAN

Hi! I have 2 questions.Om my cisco 2811 (IOS 12.4(15) T9 IPBASE W/O Crypto) i am using 3 interfaces.And i have a pool of Global addresses: 200.x.z.97-200.x.z.126 255.255.255.0!-----------------------------!FastEthernet 0/1 description WAN interfaceip...

Hi guys. I'm getting ready to implement VOIP on our LAN. I will have a PRI gateway that takes calls out to the PSTN, so I do not need to worry about WAN issues. I am going to be using non-Cisco, SIP phones, and I will have two VLAN's setup - the n...

Dear Experts & friends,This is a HA related query and I am expecting you to share your experience here and help me. A same thread i started some months ago, but couldnt continue. I am starting it again. Mr.Jon Marshall helped me, but I missed to cont...

Hi,  I am trying to configure below commands in Cisco 4506 E with SUP 6 LE but these commands are not not supporting in the switch.Even QOS command is not taking in the siwtch....This was working fine in Cisco 4500 with SUP 2..not i upgared to 4506 E...

Hello,We have a project and details are in the following.Please also find my drawing in attachWe have two locations that connect each other with point to point metro ethernet.Metro ethernet switches is installed on each site by ISP. ISP allow to defi...

I am using a cisco 2811 router.It is not booting properly.It reboots continously by just decompressing the image repeatedly....Can someone help me in this issue....

Hi GuysI m looking exacly for cisco icon mentioned exactly in the attached file.I MEAN EXACLY THE SAME COLOR (THE OLD GREAN)Thanks

Hi All,We are currently doing a project to use pure IPv6 to access both IPv6 and IPv4 services such as IPv4 web-sitesCurrently,  the solution we found out is using IPv6 NAT-PT (or PAT) to translate IP  addresses between these two protocols and enable...

Hello, I am using a 1811W and CCP for configuration.  I am trying to assign client names to devices on the LAN so that when a network scanner is used, the  client name is displayed.  I have attached part of  the running config after a binding has bee...

いつもお世話になります。ちょっと困ってます。誰かご教授ください。題記の件、詳細は下記の通りです。機器：ASR1004Version：3.1.2(15.0(1)S2)構成IXIA----->->----ASR1006---->-->-----IXIA-----------------config---------------------------policy-map Shapingclass class-default    shape average 5000000interface Giga...

Hi everyone,I'm trying to configure load balancing on a network that is using 4 3750 L3 switches.  The network is comprised of two sites with two switches at each site running HSRP and the virtaul IP is the gateway for a server between the two switch...