Routing and SD-WAN

Networkers/Guru'sCan any one please help me to understand difference/ significance of these two commands? Router:  Cisco 7200Card :    Enhanced 1 port T3 multichannel Port adapter, 1 port  /   PA-MC-T3-EC04-B#sho controllers t3 6/0:28 tabularT3 6/0 i...

Hi  every body.Let say we have a ipv6-window-host.  Let say stateful dhcpv6  is in use.  Windows host is assigned an ipv6 address by dhcpv6 server.  Will host still generate  ipv6 address by using Prefix+ randomly generated number.?if yes, then why? ...

Hello,Are there any limitations on ASR1002 for l2tp session? My ASR can't terminate more than 4023-4030 session.

Hi,in our network we are running 7206 VXR rtr as core BGP RTR and pushing traffic aroung 250megsince our traffic level is increasing we upgraded the existing router to 7606 with RP Processor with 4GB Ramafter migration we found some issue when we sta...

GreetingI have found our traffic which marked to af41 can not go out to our isp and also, incoming video traffic be unmarked also.on the interface to my ISP, I have 'mls qos trust dscp' configured. interface G1/0/8   no switchport   ip adress xxx.xxx...

I have attached scenario where i want to achieve a WAN active/standby failover with sp1 as primary link. SP1 has redundant mpls link at the HQ but at the branches they are not redundant. SP2 has point-to-multipoint leased line.I have tried to use IP ...

I know this is probably a fairly simple solution, but I have limited Cisco XPWhat I have setup is about 20 various switches with 2 Vlans. Unfortunately the gateway routeronly has a single interface for me to use so I the vlans on subinterface 0/0.1 a...

I have a multipoint frame-relay network linking R1, R3 and R4.  I also have frame-relay point-to-points linking R1 and R4 and one linking R4 and R3.  I'm running EIGRP over the entire set up and am trying to do unequal cost load-balancing to make the...

Hi.I have a 1760 with a 1 ADSL port, the carrier have a problem in the network and when carrier resolved the problem my internet connection is not restored, if I connect the carrier modem (2wire) the internet connection work, I changed the spliter, c...

Hi,While configuring an ipv6 static route, I see that if I specify the next hop ipv6 address then the traffic flows, however when I specify the outgoing interface instead of the next hop ipv6 address then the traffic doesn't flow thru, this is inspit...