Hi all,I'm a newbie in network engineering. Two days ago just the first time me using a cisco router :). can you help me solve to config Cisco ISR1100 C1111-8PLTE. I tried from many threads but still can't figure it out.I have 2 internet lines (ISP 1...
Forum Posts
I have a link that is connected to my Cisco router that is 100M. I have two different sub-interfaces on two different VRFs. One for private network traffic and one for Guest WiFi. I'd like to do QoS/Prioritization so that if there is saturation, the ...
According to sd-wan docs VPN 512 is the management VPN. It carries out-of-band network management traffic among the Viptela devices in the overlay network. By default, VPN 512 is configured and enabled. If I'm not mistaken SNMP is kind of management ...
Good day everyone,I recently acquired a cisco 3750v2 switch and a cisco 2951 router. I am also pretty new to networking. I have attempted many different things to get the functionality I desire, but I have been overthinking/don't understand enough th...
Hi, all. Please help me on this. I need OSPF routing in the following environment and I want to use Frame-Relay without using subinterfaces.
ASR1002X PPPoE Server ICMP problem with Tenda DevicesI have configured it as a PPPoE server. Everything works fine. the only problem that I have is with Tenda routers. i can't ping and also can't access themIos version is 16.3.5
Hello.I was doing an exercise on Cisco where I was asked to do specific configurations. Everything was going well. So I decided to close the pkt document and take a break.When I reopened it and decided to continue the configurations of one of the rou...
Dear all, I think Catalyst9K can check the etherchannel LB Dest Port with show command however ASR1K can also configure routed etherchannel but how to check with show command? [Cisco ASR 1000 Series Aggregation Services Routers Software Configuration...
Hi, all. Please help me on this. I have been setting up the L2/L3 configuration with the i86bi_linux_l2-adventerprisek9-ms.SSA.high_iron_20190423.bin image in the EVE-NG virtual environment. I'd like to use NAT on the switch in the image, but there i...
Hello, I would like to build a backup route, if my dsl line fails. So I made a sla tracking on my dns server with source interface Dialer 1 and made a route with the tracking activated. My problem is, that if I have this activated, I can't ping fr...
I am interested in whether all types of Viptela devices except vBond support SNMP?
Resolved! OSPF routes not updating
I am running a lab environment where I am trying to use OSPF on three Cisco 2960 routers. Routers are connected via serial interface (s0/0/0 on 1 router connects to s0/0/1 on another router, s0/0/0 on each router is the DCE and has clockrate configu...
Dear community,I have a WG M270 cluster and would like to connect to the outside world via a Cisco C1101-4P.The WG cluster (active/passive mode) has network w.x.y.130 assigned to the ports that go to the Cisco.Our network is w.x.y.129/28 (so we have ...
I'm writing a Python script that listens via a socket, and gets triggered via an EEM ping ~ I want to parse OSPF neighbor relations via regular expressions after receiving the ping (it logs into the routers and compares sh ip ospf database addresses ...
I can't access other networks from vlan10 & vlan 20 but I can access vlan10,vlan 20 from other networks(OSPF routing protocol is used in my all routers).I can ping vlan10&20 from my BRANCH A router but not ping between the Vlan's (10&20).For your ref...
