Resolved! VRF VLAN members
Hello,Can a VLAN be a member of two VRFs on 7010? if so, why would be set up to be on two different VRF? Thanks
Forum Posts
Hello, I'm trying to establish sdwan solution in my lab but i have to have c8000v routers in inline mode - controllers and routers are in one DC and controllers are behind c8000v Someting like figure 71 in design guide https://www.cisco.com/c/en/us/...
To the BGP Gurus,I may be "flogging a dead horse" here but here goes........:High Level Summary:===============Are there any gloabl BGP neighbours cmds (i.e. NOT under VPNV4 or IPV4 address-family functionality) to perform a "AS-override" function?Th...
Hi All,I have a Cisco ISR c1117 router at home that I use to replace the standard sky router. I had setup everything and it was working perfectly fine, I also upgraded the iOS-xe and had full connectivity until I came back from holiday.I've plugged i...
Hi Cisco eXPerts. I'm having an issue with a GRE tunnel on the Cisco NCS-5502-SE router running the IOS-XR 7.3.2 64 bits. This is my scenario [server-a] ==> [core-router-1] === GRE tunnel ===== [ internet ] ===== GRE === [edge router] <== [server-b] ...
so we have cisco 1841 that has a PPPoE connection to the ISP. what we want is that this router act as dumb bridge router while handling the PPPoE connectionwe want to connect a fortigate firewall behind it and that the 1841 act as a transparent bridg...
Hi I'm looking for a similar command that i used on nexus7k (routing-context vrf) in asr9k (IOS XR). I used this to test connectivity from a specific vrf.
Hello!I'm a networking Student and I've recently made bounds and leaps in my HomeLab (trivial to some of you but huge to me).I'm running into one issue that my hours of Youtube and Googling I have not been able to come up with an answer. Here is a To...
Is it possible to use LACP and NAT over Layer3 port-channel?Cisco 4351
hi, i got a cisco 4K router with IOS-XE 17.3 and have voice and sec K9 license bundled. we still use "smart" transport and don't use "CSLU" transport method in our smart license. my question is, is the smart license via CSLU mandatory? i can see the ...
Hello Expertsmy question is a little different, i used to use SSH connection to access router with normal behavior, but yesterday i can`t login usually by ssh connection and i get error message (Router refused connection ) so i access by telnet and a...
Resolved! route redistribution OSPF - > EIGRP
Hi,during redistributing the OSPF into the EIGRP, I notice the network 10.45.1.0/24 is injected into EIGRP in form of OSPF.Since the network 10.45.1.0/24 is showing direct connected in the RIB of R3, why it can be redistributed into EIGRP as OSPF?As ...
Hi,all routers in a MPLS domain need a LIB table.To build the LIB table routers in a MPLS domain need to use LDP to exchange the labels with their neighbors via multicast. Meanwhile the LIB is kind of a "mapping table" of netowrk, MPLS label and next...
Hello Guys What is is use cases of OSPF P Bits , we we need it ??? thanks
Resolved! Cannot enable SSH on 4331
Hi there, im having a few issues enabling SSH on one of our 4331 ISR routers. ABN_WAN1_4330(config)#do sh ip sshSSH Disabled - version 2.0%Please create RSA keys to enable SSH (and of atleast 768 bits for SSH v2).Authentication methods:publickey,ke...
