Hi all. I am trying to do some labbing in CML with the SD-WAN images, but I have hit a roadblock already before I got started. I have tried to configure VPN0 for my vBond/Validator, but I am not able to commit when I configure gi0/0 interface. I trie...
Hello,I setup a test alarm notification in vManage using the option for Webhook so that we can be notified when a TLOC goes up/down or BGP peer state changes. I added the Incoming Webhook to teams but still no luck. Any advice would be greatly apprec...
Hello All, am trying to configure BGP as attached diagram and am able to see routes from CSR19-192.168.0.0(Internet by NAT) , but am not to ping from EBPG Routers CSR12/RTR17. current configuration is mentioned below . Thanks for your tips so that ...
Hi,I am trying to set up a connection via OSPF between my Cisco 3850 layer 3 switch and my FortiGate 60E firewall throw OSPF, but it's not working, has anyone done it before. I pasted my configuration below, note if you see misconfiguration it is jus...
Apologies in advance for the crude drawing There's an original setup where the green dmvpn did not exist, R1 is the home office R2/R3 are remote offices with substantial bandwidth to the home office, R4/R5 routed everything to R2/R3 over a GRE tunnel...
みなさん、こんにちは、IPOEについておしえてください。できればシスコルータによるコンフィグも
Hi,When i push the template into a CSR1000 it fails with this error. please help!Env: EVE-NG LABCSR : 16.12.5vManage/Smart/Bond: 20.12.5
Good evening, I installed a C-NIM-4X card into a Cisco C8300-2N2S-6T router, when I looked at the status is said "booting" and I can't access it.Can someone help with getting this card becoming active please?
Hello,So when I was configuring the interfaces, I couldn't configure the ingress and egress in 8200L routerip flow ingressip flow egress.Do we have any alternative command for this?
I have a Firepower 2130 that homes all of my S2S VPN connections, as well as some AWS Direct Connect and Microsoft ExpressRoute links.The FW has static routes for VPN destinations, to push them over the appropriate outbound interface, and a route-map...
Hello. We are switching from IR809 to IR1101 routers and I have a technical question regarding antenna and cable selection. So far we have been using ANT-4G-DP-INTNC antennas and CAB-L400-10-TNC-N cables. The IR1101 with the P-LTE-GB module has an SM...
Hi,I would like you to examine the scenario below; this was meant to be tested in the customer's environment. I opened the packet tracker and attempted to create the same topology, but it isn’t functioning , so I would like to find out if it will wor...
Hello,I wanted to find out if there was a work around for this issue, on IOSXR code 6.5.3, which does not have the option to specify "bind-source interface <SOURCE_INTERFACE>". Regards,Abid Ghufran
Hi ! I have a multicast setup in my network using PIM-ASM. For some reason a router in my network stopped responding to IGMP requests. Although the show commands for IGMP showed everything works. Has anyone experienced the same thing? I’m planning to...
Hi, I'm trying to set up OSPF between 2 routers with subinterfaces. Unfortunately, OSPF doesn't come up with the subinterfaces. If I set up OSPF on the main interface, everything works fine. The connection is between different sites in the country. C...
