I read this in cisco site about certificat . Controllers: A device certificate signed by Digicert is installed for its own identity which uses the SHA 256 algorithm. In software, the following root certificates are present:◦ Digicert (formerly Sy...
Forum Posts
Resolved! Static Nat
Hi GuysI have two edge routers with public IPs suppose it R1(1.1.1.1),R2(2.2.2.2)and i need to map my local server SRV(192.168.1.200) to both ISPs.the required: if R1 (intG0/0/0) goes down the R2 take place and serve the request.@Nat @Routing
Hi all,we have Cisco cmts cBR8 ISIS Configuration using IPV6 ISIS Protocol per Level 1 but seems is different now on the new 17.6.1xtill now ISIS router was configured as follows: rs#show run | s router isis ipv6 router isis dc-maw ipv6 router isis d...
Hello;I want to understand how the policies work in the SD-WAN and how are distributed? Thank you.
Hello,I have two ASBR routers which are connected to the same ISP AS6939 in BGP full-feed IPV4 and IPV6.The two ASBR routers are connected in full-mesh.=> I want to prioritize IN/OUT traffic on Router1=> Router2 will be used if Router1 goes down Rout...
Resolved! Static Routing Noob
Hello, I'm taking an advanced routing course at college and we've been tasked with a project to configure routing by only using static routes to make each PC pingable from all the other PCs. I've been at it all day and I'm just stuck. I don't know wh...
delete post, thanks.
Resolved! how to trunk thought static route ?
VLAN gateway on different switch with access port how to trunk thought static route if it not possible is there a way around it ? i just get in to learning networking for two week stuck on this question for 4 day now any subject i should look ...
We are trying to determine the End of Vulnerability/Security Support:HW for a Cisco ISR4451-X.Following the eol documentation on the following link, it states February 8, 2022, is this correct: - https://www.cisco.com/c/en/us/products/collateral/rout...
R2: R2 can ping R4 as it is direct connected R2#ping 24.0.0.4Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 24.0.0.4, timeout is 2 seconds:!!!!! R1 cannot Pinfg R4ype escape sequence to abort.Sending 5, 100-byte ICMP ...
Would like to ask on how to know on what is the use or purpose of 200GB SSD in ISR4451-X/K9 router. What show commands are we going to perform in order to check the SSD capacity/free space/used in our router? Thanks cisco ISR4451-X/K9 (2RU) processo...
Hi Everyone, As part of my homelab I purchased a number of older Cisco Routers and Switches. I've managed to learn a great deal about getting these setup and running. Now that I've finally been moved across to FTTP I want to replace my consumer route...
Hello everyone;I want to ask how every component in sd wan architecture really works in details?Thank you.
Hi i still wondering what happen in my cisco router,my command automatically deleted by router, i'm not doing anything not even reload the router.Please help.the command is ip nat source ip addr1 ip addr2 extendable. Thank you
Hi,I am trying to make IPsec tunnel between two firewalls.The network setup is as below, which is the firewall at one site is behind vEdge and the other firewall is not.I am not considering using Port-Forwarding option using single VPN0 IP because I'...
