hi everyone ,i need to convert cisco cammand outputs into json format for automation can any one please help me on this please,
Forum Posts
hye all,Can anybody tell me the difference b/w the commands ip proxy-arp and ip local-proxy-arp.I've complete understanding of Proxy Arp but the thing i can't understand is why both these commands are there.
Resolved! Eigrp metric
Hello everyone, I start by saying all the formula for calculating the eigrp metric is clear except for one data. A simplified formula is 256 x [(10 ^ 7 / Least Bandwidth) + cumulative-delay]. I have not found anyone who explained it the only site I f...
We have been trying to automate network configurations of routers using python but it removes certificates key which are used for dmvpn after it login to the router
Hey guys, I'm trying to ping PC1 to PC3 but I'm not able to.I used router rip version 2 command in all three routers, entered all IP addresses including ipv6 and ipv6 unicast-routing command. Here's the .pkt fileThank you in advance for your help. h...
Hello experts, and good day to you all. I have questions regarding OSPF routing on an extensive wireless network. We have a large wireless network (ring type) implemented just a few years ago, and it has been running just fine until now. We used defa...
Resolved! OSPF on Firepower Cluster with FTD 6.2.3
Hello, does anyone have experience with OSPF on a FTD cluster? I have two FP 4120 running FXOS 2.3(1.99) and FTD 6.2.3.83 on top. The FTDs are configured as a cluster and I am using Firepower Management Center to configure it. The FTD cluster s...
Dear All,Please find my requirement in the two figures below Figure 1Figure 2Brief Synopsis In Figure AI have a Router and two ISP links connected to it. The other end of the Router is connected to the LAN via the Switch In Figure BI have two Router...
I have an MTU issue I can’t figure out, on a Cisco 1100 when I configure a GRE tunnel and specify the MTU I get and fragmentation error Int tun 650ip mtu 1330 %Warning: IP MTU value set 1330 is greater than the current transport value 1306, fragmenta...
After random time (1-2 Days) internet access stops for Lan users. After doing shut - no shut for dialer 1 interface it starts working normally. Can anybody please help Below are the PPPOE configurationinterface GigabitEthernet0/0/0 description Etisal...
Hello folks, I need to configure bgp-evpn over mpls between 2 PEs. Actually, it is hub and spoke topology with 2 hubs. At the spoke side the client is attached to vlan(Ethernet Segment). Under interface vlan I am using the following commands:no ip ad...
Resolved! Mail use the wrong ip
In my Cisco Firepower, I have set a NAT rule inside->outside that use my internal and external ip of my internal mail system. That work fine, I receive mail, and I can connect to it from outside our office, but when I send a mail, it seem to use the ...
When using the Viptela SDWAN API, I came failure message saying "Processing timeout. Failed to Configuring device with CLI template". I'm trying to attach my device template to a vEdge. What should I do?
Hi all,I have made some changes on our ASR9K, but it doesn't allow me to save the config.Does any one of you know what's the reason and how we can save it?It showing as below:% Failed to commit one or more configuration items during a pseudo-atomic o...
Hi guysI am testing SDWAN with 2 cEdge ISR4331. Both of them use G0/0/0.3 for Internet tunnel and G0/0/0.4 for MPLS tunnel. From vManage, I want to see the interfaces traffic for each tunnel, but it only show traffic on G0/0/0. How can you resolve th...
