Hello, I recently made the switch from Peplink Balance 20 to Cisco RV345. On the Peplink I could do Policy Based Routing by MAC address and force certain machines through a specific WAN. On the RV345 I only seem to be able to do this by IP address. I...
I am facing issue, I have configured a CGR 1120 router and configuring BGP for two ISP with IP address On Router Interface. Both the BGP came up, but after 3-4 hour both the Bgp neighbours goes in to idle state and when I try to ping neighbours IP bo...
Dear I hope you are doing well.I have a problem with Nexus 5020. The command "IP routing" is missing. so I can not access any device in any other VLAN.Is there any solution for this problem. or this model doesn't support routing between VLANs
Dear sir :kindly, i have following scenario:CCTV Camera --connect to cisco switch 9200--- connect to spoke (ISR4321/K9) ------dmvpn tunnel--- HQ ( hub router (ASR1001-X ) ----(server ( 10.9.5.130) receive multicast traffic from CCTVmy issue is source...
Hi all, I am wandering, if the worry is having to many BGP Sessions on Router A, is there are any difference between the following 2 scenarios? If there are no differences, is there a BGP feature that helps overcoming this problem?Scenario 1:Scenario...
Syslog is great, but it is much easier in a pinch to see log messages right in console/buffer. Is it safe practice to use the maximum log buffer size shown in Cisco IOS and IOS-XE? -3850 running 3.6.6 shows range of value for `logging buffered ` a...
Hi everyone,First time posting although I've lurked plenty looking for answers. Any help from you folks is much appreciated.I've got a Cisco Aironet 1532i with the autonomous IOS. I'm trying to use the wireless access point to give out different IPs ...
I need help with using IP SLA to route traffic to backup ISP when primary is down and revert back to primary when it comes back up. We have two buildings each containing a core switch (3850) and a FTD firewall connected to a different ISP. Each cor...
Are VRF's necessary to be PCI compliant or can I just do a PCI VLAN and add ACLs?
Hi guys,Are they any bandwith limitations per SA on IPsec l2l tunnel? Didnt make it more than 300Mbits on an 1Gbits wanlink Firepower 2140 on both sides
I am running RSP1A SDM Template on ASR903, does anyone know, maximum how many BGP sessions can handle the router? I know Pretty unusual question. Any help would be very much appreciated. Davide
Hi, Can someone please assist with my exam preps. The interface on PT doesn't want to take IP address on interface f0. The model is 819HGW.
HI, I have configured an ISR4321 Router as LNS for PPOE IPV6, but I met an issue when I would configured interface virtual-template, I couldn't configure the " ipv6 nd prefix 2001:77::/64 " under the interface virtual-template. is there a solution ...
HelloI have a GSR 12416 router at my site and its coming with 3 power supplyMy question is can the router work with only one power supply even after i unplug some cards out of the slots ?
Hi All, Have tried accessing SD-WAN sandbox from both Postman & Python but while access its showing error on invalid user/password. Thanking You, Hardik
