Routing and SD-WAN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi. Our network has three core switches. We are running OSPF on each core switch for routing. The design looks like this:                                     Firewall                        |SWA <----> SWB <-----> SWC From A to B there is both a L2 E...

NT_01 by Level 1
  • 1596 Views
  • 2 replies
  • 0 Helpful votes

HelloI currently have two ASRs, a 9006 and a 9010 that are currently in production, I have just purchased two additional RSPs so that I can have RSP redundancy.The router is already in production and I'm wondering about the procedure for setting up a...

JGFR by Level 2
  • 1459 Views
  • 2 replies
  • 0 Helpful votes

I have two ports 80 and 443 that come out as open when I scan my outside interface.I have not nat anything at all from the outside interface ip to anywhere(all it does is just an overload NAT), but I Natted from routable IPs that I have to the same i...

George-Sl by Level 4
  • 1827 Views
  • 3 replies
  • 0 Helpful votes

Hello,So I currently have a bidirectional route leak from two VPNs and it works just fine. For example:seq1: Match: VPN200 Action: Export to VPN1seq2: Match: VPN1 and Prefix "X" Action: Export to VPN200 When I try adding another set of sequences to r...

Dear Community, i have the following issues,C800 series router, 6 vlans, 4 vlans work perfectly, giving out dhcp leases, internet and so on.But Vlan 50 and 60 no giving out dhcp adresses. see attached show running-configenaC897#show running-configBui...

m.yildiz by Level 3
  • 5083 Views
  • 17 replies
  • 0 Helpful votes

Hi,I have a direct inquiry and i hope to get a clear reply. I'm still in the process of discovering/exploring Cisco Viptela SD-WAN whole solution architecture from a theoretical perspective. I need to determine the compatible ASR1K XE standard based ...

AIR-CORE by Frequent Visitor
  • 666 Views
  • 1 replies
  • 0 Helpful votes

Hi AllCouple of BGP questions,Firstly, If I have 2 links via IBGP to another router, what do most people do to make it prefer one path over the other, weight is only local, so do people use local pref in and out the router so the traffic is preferred...