Hi
I am trying to configure MFR on my 10K router, It cannot take the interface-dlci command. Once the dlci is configured I am getting an error message, what could this be. is it a bug that needs to be fixed by cisco?
below are my configs:
interface MFR0
no ip address
no keepalive
frame-relay intf-type dce
!
interface MFR0.100 point-to-point
ip address xxx.xxx.x.x 255.255.255.252
!
Router(config-subif)#frame-relay interface-dlci 120
Router(config-subif)#
1d20h: %GENERAL-3-EREVENT: dlci_create: No c10k_tt_hwsb
-Traceback= 6125CD0C 60EC4E2C 60EC572C 60ECF648 60EC3F94 6053608C 601C5AA8 605511FC 606585E0 606585CC
