I have just purchased some Cisco 1800 Senors and tested them in different locations and now we are looking to permanently install them. I having them installed right next to a data jack with the RJ45 between the two is bit of and eyesore. I tried looking online to see if I could see one that has been installed with no luck. Has one installed any 1800s or have any documentation on how to install one?
The 1800s is of no use if there is no DNAC involved.
Calling it a "sensor" is really not accurate because it only checks the CU, checks if it can join an SSID and ping a few set-specific hosts.
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: