cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
520
Views
0
Helpful
1
Replies

1800s sensor

b.angel
Level 1
Level 1

I have just purchased some Cisco 1800 Senors and tested them in different locations and now we are looking to permanently install them. I having them installed right next to a data jack with the RJ45 between the two is bit of and eyesore. I tried looking online to see if I could see one that has been installed with no luck. Has one installed any 1800s or have any documentation on how to install one?

1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame

The 1800s is of no use if there is no DNAC involved.  

Calling it a "sensor" is really not accurate because it only checks the CU, checks if it can join an SSID and ping a few set-specific hosts.  

Review Cisco Networking for a $25 gift card