cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
404
Views
0
Helpful
2
Replies
j_friedrich
Beginner

1941W PPTP routing

Hi,

     I am just learning the ropes with this stuff, so go easy on me;)

Anyways, just acquired a 1941W and want to accomplish the following.....

I have setup a pptp connection thru strongvpn.  I want to segregate traffic to allow an ip or range of ip's to access the internet thru the pptp link.  Also, I want them to see local traffic on the same subnet to access file resources and so on.  However, I don't want ALL traffic to go out of the PPTP link.  Certain devices will use this PPTP link, other devices will use the ISP address.

Not sure how to accomplish this.

Weblinks / tutorials and or commands are greatly appreciated.

Thanks for everyone's input!

Jason

2 REPLIES 2
M-Hassanien
Beginner

Dear Jason,

Can you clarify the current setup with a drawing if possible?

The router is a client terminating a PPTP / L2TP connection.  I haven't decided which to use yet.  So, a range of IP's will use this connection to access the internet.  For example, using StrongVPN as the PPTP / L2TP service.  Other IP's will use the local ISP generated IP.  Not sure how to do the routes...


Possible on one WAN interface?  OR one WAN interface for the ISP IP and the other for the PPTP/L2TP tunnel?  I would prefer to use the one WAN interface.  I know I can do it with 2 WAN interfaces.


Thanks for everyone's input.

Jason