Hello my Seniors,
Kindly help me here,
I have 1 router with 2 isp links,
I want to terminate this two links to be used as dulink active\active failover where all of them will be used actively
The router has 2 gigaports G0/0 and G0/1 and 4 FastEthernet ports Fa0/1-Fa0/4
In the configuration, i dont want them to act as two networks.
Then i want to make the router to route traffic from multiple VLANs over the same physical port by creating subinterfaces
Then configure Fa0/1-0/4 to switchport mode trunk so that i can i can add any other additional managed switch in future
isp 1 ip 192.168.78.4 /30 and isp 2 192.168.63.4 /30
Question.
1. How will i configure dual isp and do i configure on both giga ports
2. Which giga interface will i configure subinterfaces
3. How will the i enble routing between the interfaces
4. Will i use 1 isp to nat outside
5. Which public ip will i be using or i can use both
Dan Wabwile
IT Support