cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
352
Views
0
Helpful
1
Replies

2800 question

Ahmede
Level 1
Level 1

I have a 2800 router with two serial interfaces, for some reason the second serial showing the clock rate command. we tried to remove it with the "no" but it does not work.. Whenever we connect the serial cable to this interface, it shows as DCE not DTE (show controllers s0/0/1).. How can we fix that?

Thansk in advance..

1 Reply 1

Richard Burts
Hall of Fame
Hall of Fame

Ahmed

It might help to know what kind of interface this was (and what kind of controller). But in general the determination of DTE or DCE depends on the cable that is connected. Can you tell us about the cable and can you verify whether it is a DCE cable or a DTE cable?

HTH

Rick

HTH

Rick
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card