2811 and a WiC-1ADSL-I-DG

[ddevecka]

We have open a division in the UK and are using DSL as a back up to a T1-E1, so I was going to use a standard DSL Modem but thought the WiC-1ADSL-I-DG would be better. However I can seem to get the card up and running. Here is the interface config and sh int atm.

interface ATM0/1/0

ip address dhcp

ip access-group 102 in

ip inspect SDM_LOW out

ip nat inside

ip virtual-reassembly

no atm ilmi-keepalive

dsl operating-mode auto

ATM0/1/0 is down, line protocol is down

Hardware is DSLSAR (with Alcatel ADSL Module)

Internet address will be negotiated using DHCP

That's part of the sh int amt.

Anyway I can't get the interface to function and I was looking for any help.

Thanks.

[ddevecka]

Also when I put it into loopback I get nothing.

[ddevecka]

I was wrong when I put it into loopback ATM is up and line protocol is up as well.

[paolo bevilacqua]

Hello,

WiC-1ADSL-I-DG if for ADSL over ISDN, that is quite rare, unless you have this type of ADSL, it will never work.

Hope this helps, please rate post if it does

[ddevecka]

My boss in at location in the UK and said he thought this is what they used?

[paolo bevilacqua]

Well you should confirm with telco or physically, if it is ADSL over ISDN will work, else it won't.

ISDN BRI is easy to tell as it has a box called NT1 on which there is an RJ-45 presenting the S/T interface.

[ddevecka]

I will check this out and post as I find out. Right now we installed a Linksys DSL Router and are working from that.

[paolo bevilacqua]

If the linksys works, that means the line is not ADSL over ISDN.

The right card would be then WIC-1ADSL or HWIC-1ADSL depending on the router model.

Hope this helps, please rate post if it does!

[sohaildxbfze]

Hi Paolo,

I have same issue, my inventory is

Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.3(14)T5, RELEASE SOFTWARE (fc2)

NAME: "WAN Interface Card - ATM (With ADSL module)", DESCR: "WAN Interface Card - ATM (With ADSL module)"

It was working for last 3 years, out of no where stopped working. Then i connected dlink wan router & checked that if modulation type is ADSL (multimode) it doesnt work. If it is ADSL2/ADSL2+ then it works. Service provider is taking lot of time to tell us exact modulation time.

I want to confirm that HWIC-1ADSL will work for above 2811+ IOS,, so i can buy & do it myself

thx.

[paolo bevilacqua]

Of course it works.