3800 service-module session won't connect

[davebornack]

I always have problems with this when configuring 3845s with a Switching module.

From what I understand, you just need to IP the interface gi2/0, and you're good to go, but I keep getting this:

mdf-rt-01#service-module gi2/0 session

Trying 10.52.240.1, 2130 ...

Here is relevant config:

interface GigabitEthernet0/0

description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$

no ip address

shutdown

duplex auto

speed auto

media-type rj45

interface GigabitEthernet2/0

description INTERNAL_ETHERNET_SWITCH_MODULE

ip address 10.52.240.1 255.255.240.0

ip verify unicast source reachable-via rx allow-default

ip helper-address 10.128.5.59

ip helper-address 10.128.5.50

no ip redirects

no ip unreachables

ip nbar protocol-discovery

ip pim sparse-mode

[paolo bevilacqua]

Which exact module is this? "show diag" if you are not sure.

[davebornack]

My apologies:

Slot 2:

NME-XD-24ES-1S-P: EtherSwitch SM 24 10/100T PoE + 1 SFP + StackWise Port adapter, 1 port

Port adapter is analyzed

Port adapter insertion time 04:00:11 ago

EEPROM contents at hardware discovery:

Hardware Revision : 1.0

Top Assy. Part Number : 800-25012-02

Board Revision : A0

Deviation Number : 10-1987

Fab Version : 03

PCB Serial Number : FOCxxxxxxx

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Product (FRU) Number : NME-XD-24ES-1S-P

Version Identifier : V02

Base MAC Address : 0025.84db.f300

MAC Address block size : 128

EEPROM format version 4

[leo.laohoo]

Try removing all the config on Gig 2/0 (default interface Gig 2/0) and just put the IP address.