cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
494
Views
0
Helpful
3
Replies
ROY THOMAS
Beginner

3925 router

I have a new 3925 router and it came with 1 VWIC3-4MFT-T1/E1 card installed. I added a 2nd one and although it shows up in inventory, the interfaces do not show up in configuration in any form, interface or controllers. I used to just install a card and it would be recognized, is that no longer supported and is it platform specific or IOS specific?

Thank you

Roy

1 ACCEPTED SOLUTION

Accepted Solutions
paolo bevilacqua
Hall of Fame Master

Configyure card type x/y  E1 ot T1

View solution in original post

3 REPLIES 3
paolo bevilacqua
Hall of Fame Master

Configyure card type x/y  E1 ot T1

View solution in original post

Thank you, that did it. My bad; it was right there in front of me the whole time. The router statement said,"card type needed for slot 0/1. I need to slow down and read more carefully.

Thank you

Roy

To slow down is always good.

Thank you for the nice rating and good luck!