4510

[AJ69]

Trying to setup a 4510. Having problems with VLAN 1 not coming up. VLAN 1 shows down - down. No shut command is not working. HELP!!!

[Richard Burts]

Do you have at least one port in VLAN 1 with an active device plugged into that port? Without at least one active device the VLAN will not come up.

HTH

Rick

[ankurbhasin]

Hi Aj,

As stated in pevious post you need to have atleast one port assigned to vlan 1 to make it active. But even if you configure any port as a trunk port it will bring your vlan 1 as up.

Try that and update us.

Regards,

Ankur

[singh.ashish]

Hi,

Configure one port as a trunk.

regards...

Ashish Singh

[thisisshanky]

Your SUP engine (whether 3, 4 or 5) has layer 3 capabilities on it. No matter what you do with a "no shut", under the vlan interface...you will not see it up/up until atleast on client is connected to any of the ports that fall under vlan 1. So connect a laptop or a PC to one of the ports, put that port into vlan 1 and you should see Vlan 1 status up/up. You can also verify this by executing a show ip route on the switch.

[AJ69]

Cool... Problem is solved.

[singh.ashish]

Hi,

Can u post.... wat was the solution ?

regards...

Ashsih Singh