Re: 7500 WAN Router Port Numbering

NETWORK OIT · ‎12-30-2013

Can someone explain what the port numbering that i am seeing using CDP means please?

S0/0/0/15:0

what i understand is as follows, Serial Module/Slot/Port/???:Controller Channel?

we have an ISP which has NNPs with XO. our ISP is providing MPLS services over T1/T3 circuits.

-------------------------

Device ID: 7507-3

Entry address(es):

IP address: 10.1.1.1

Platform: Cisco RSP4, Capabilities: Router

Interface: Serial0/0/0, Port ID (outgoing port): Serial0/0/0/15:0

Holdtime : 127 sec

Version :

Cisco IOS Software, RSP Software (RSP-JK9SV-M), Version 12.4(5c), RELEASE SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Compiled Wed 01-Aug-07 22:40 by karnagar

advertisement version: 2

Thanks in Advance.

Joseph W. Doherty · ‎12-30-2013

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

It's been years since I've been on a 7500, but "extra" numbering might be related to a VIP.