I have a customer that we sold them a 10 Meg point to point ethernet circuit. We had them on a circuit that included several hops on a 15454 and a couple 3560's that we were policing at 10 meg . We cut them to the 7609 we are policing at 10 meg and dropping the packet after that. The 7609 does a much better job policing which caused issues with there network. We are looking to be able to offer them the 10 meg with up to 10% bursting to 11 Meg total. I have been searching and found that there are several options with Cir / Mir / Pir. I was looking for a sample of what the config would look like. Any help would be great.
Jeff
here is what I am using today.
interface GigabitEthernet9/1
description wan
switchport
switchport access vlan 3002
switchport mode dot1q-tunnel
no cdp enable
spanning-tree portfast
spanning-tree bpdufilter enable
service policy input 10x10meg_point_to_point
end
Policy Map 10x10meg_point_to_point_policy
Class 10x10meg_point_to_point
police cir 10000000 bc 312500
conform-action transmit
exceed-action drop
Class Map match-all 10x10meg_point_to_point (id 5)
Match access-group name MAC
