cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
191
Views
0
Helpful
3
Replies
Highlighted
Beginner

887va Resets after switch off

Hi All,

We have to switch of our Cisco 887va router over the weekend, when we come back on the Monday to switch it back on the router has reset itself or not holding the current configuration. We have to re-input the configuration each time! any help would be much appreciated.

Many Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Mentor

The first question to ask is why you switch off your router ...

Back to your question:

1) Did you save the config? ("write mem" or "copy run start") after doing your configuration?

2) Is the config-register set correctly?

cisco#sh ver | i register

Configuration register is 0x2102

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni

View solution in original post

3 REPLIES 3
Highlighted
VIP Mentor

The first question to ask is why you switch off your router ...

Back to your question:

1) Did you save the config? ("write mem" or "copy run start") after doing your configuration?

2) Is the config-register set correctly?

cisco#sh ver | i register

Configuration register is 0x2102

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni

View solution in original post

Highlighted

Thanks for your answer Karsten.iwen,

I've done the:

Router#copy running-config startup-config

Hopefully that will work, the company gets powered down at the weekend, to save on power.

Many thanks for your help.

Highlighted

remember that you have to save the config after every change to make that change permanent.

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni