Adding additional block of public IP's to UC540 WAN
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-05-2013 07:30 PM - edited 03-04-2019 09:46 PM
Hi,
I am trying to add additional block of 4 public IP address to UC540.
When trying to create NAT pool, i am receiving error the new range is not in the same subnet as WAN.
Current WAN subnet is /30, but new block of IP's change after first 2 octets.
Obviously if we change WAN subnet, the connection drops.
Any suggestions on how to add this range to the UC540. Additional IP's are only being used for 1 to 1 NAT
Thanks in advance
Guy
- Labels:
-
Other Routing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-05-2013 08:12 PM
Hello,
Nop, that's a requirement for a NAT pool bud,
I have seen this behavior on the last code of some of the Cisco devices such as the ASA but due to customer requests they have changed so the ASA can be configured with the desing in mind you are looking for.
For the UC540 this is not possible (yet) so the only solution is what you suggested bud
Regards,
Jcarvaja
Follow me on http://laguiadelnetworking.com
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
